About this chapter
This chapter describes all basic procedures for the physical installation of the projector.
4 Installation procedures
- 4.1 Pulse RCU battery installation
- 4.2 Connecting the projector with the power net
- 4.3 Displaying and Programming addresses into the RCU
- 4.4 Using the XLR connector of the RCU
- 4.5 Setting the projector addresses
- 4.6 Alignment of a table mounted projector
- 4.7 Alignment of projector in the rigging frame
- 4.8 Installation of an input board
- 4.9 Removal of an input board
- 4.10 Software update