4.4 Power on projector

How to power on

  1. Press the mains switch at the side of the projector to switch on this projector.

    Image 4–10 Mains switch
    • When '0' is pressed, the projector is switched off.
    • When 'I' is pressed, the projector is switched on.

    The projector starts up to Ready mode. The Power on/off button will blink until Ready mode is achieved. Once in Ready mode, the Power on/off button will be lit WHITE.

    The start up screen is displayed on the touch panel. Once the startup is completed, the status screen will be displayed.

    Image 4–11

  2. Press the Power on/off button on the projector, or the Power On button on the remote control.

    The projector will continue to power on mode. The Power on/off button will blink until the projector is ready for projection. Once the projector is fully started up, the Power button will be lit BLUE.

    Image 4–12
Note: The current mains input voltage is indicated on the voltmeter just above the power switch.
Note: The background image of the startup screen and info screens can be changed with Projector Toolset with an installed UDX plug-in.