About this process

This process overview provides a high-level description of the different installation stages for the ILD 90° lens and refers to detailed step-by-step procedures. Follow this process flow and the instructions in the referred procedures precisely.

Process overview

1. Install the bottom plate of the lens support.

   See procedure “Installing the lens support bottom plate”.

2. Set the Back Focal Length in nominal position.

   See procedure “Set the Back Focal Length to nominal position”.

3. Adapt the UST lens orientation for the application.

   See procedure “Configure the ILD 0.37 UST 90° lens”.

4. Install the UST lens.

   See procedure “Lens installation”.

5. UST lens pre-alignment.

   See “ILD 0.37 UST 90° lens pre-alignment”.

6. Install the lens support bracket.

   See “Installing the lens support bracket”.

7. Final installation of the projector with UST lens and lens support.

8. Fine tuning the UST lens.

   See “ILD 0.37 UST 90° lens fine tuning”.