UDM Series: service and repair

Goal

This training concentrates on the technical side of UDM-series projectors. By the end of the course you will have a good understanding of the projector modules, their functionality and how they interact. In combination with the set of diagnostic tools available in the projector this will allow you to efficiently troubleshoot issues. Furthermore the replacement procedure of the important modules and the Service Strategy are explained.

By the end of the course participants will be able to do high level troubleshooting in case of issues and they will be able to perform replacement procedures using service manual and instructional videos (where available).

Target Audience

Service engineers, repair staff, maintenance engineers, product experts, and other technical professionals.

Agenda

Day 1

• Projector modules
• General block diagram
• Communication flow
• Power flow
• Optical components
  • Modules
  • Functionality
  • Alignment
  • Troubleshooting
• Signal flow
• Cooling circuits
• Sensors
• Safety (summary)
• Replacing the main projector modules

Day 2

• Diagnostic tools
  • Test patterns
  • User Interface
  • LEDs
  • Notifications
• Log file analysis and practice
• Warranty
• Service strategy
• Certification test

Prerequisites

• Barco high brightness safety training
• Basic knowledge about network communication configuration (IP address; subnet mask; WiFi)
• Laptop with administrative rights (to install the control software)

• Objective

  By the end of the course you will have a good understanding of the projector modules, their functionality and how they interact. In combination with the set of diagnostic tools available in the projector this will allow you to efficiently troubleshoot any issue. Furthermore the replacement procedure of the important modules is discussed and the Service Strategy is explained.