4.5 Connecting the projector with the power net

Caution: Use only the power cord supplied with your device. When no power cord for your region/country is provided, contact your dealer. The power cord must be suited for the electrical ratings indicated on the product ID label. Only power cords according to the local electrical code regulations can be used.
Warning: Do not attempt operation if the AC supply and cord are not within the specified voltage and power range.
Prerequisites

Before connecting the projector with the main power net, check if the main power net meets the specification as described in the chapter “Installation requirements”.

How to connect with local power net

  1. Connect the female side of the power cord with the power input socket of the projector.

    Image 4–10
Caution: Once the projector is switched from ready or on mode to standby mode, the cooling fans will continue to run for approximately 30 seconds to ensure that the projector and light source have sufficiently cooled, at which point the fans will automatically decrease to standby. To avoid thermal stress that can lead to premature light source failure, never unplug the power cord while the cooling fans are running. Never unplug the power cord to power down the projector, first switch off the power switch and then unplug the power cord.