Location and unit selection

1. Navigation side bar: Configuration
2. Central work window: Detail View or System View

3. Click on the top area of the desired unit in the central work window.

   

4. Right panel: Adjust unit

About TCI mode

Tri-combo input cards have six possible connectors. Due to limited card resources, only four of these input connectors can be active at a time. It is possible to select which group of connectors are active, by using TCI mode.

TCI mode has three different options:

Note: The disabled connectors will not lose their configuration in the software. Any signal that is sent to them will not be processed. To reactivate the connector, change the TCI mode and the same configuration will be active again.

Tip: Each TCI card can have its own mode independent of the other cards.

• Top 4, disables the bottom two connectors.
• Middle 4, disables the top and bottom connectors.
• Bottom 4, disables the top two connectors.

Select the desired TCI mode from the drop down after the desired TCI Mode Slot #.

If changes were made, click the save icon () in the header.