Location and unit selection
- Navigation side bar:
- Central work window: or
Click on the top area of the desired unit in the central work window.
Image 7–44 - Right panel:
7.8.4.6 Setup
Lock/unlock the front panel
The front panel can be locked to prevent accidental touches or unwanted modifications to the Encore3.
Lock or unlock the front panel by clicking the slider after .
If changes were made, click the save icon (
) in the header.
Unit ID
The unit ID is used during linking and allows the software to differentiate each Encore3 with a designated number. This number can either be a ‘0’ or a ‘1’. It is recommended to assign ‘0’ to the host unit.
Enter a desired ID (‘0’ or ‘1’) in the input field after . If two units are linked, see “Linked units” for more information.
If changes were made, click the save icon () in the header.
Flash front panel
Flash front panel will gradually increase and then decrease the brightness of the front panel. This changing brightness can assist in locating a desired Encore3.
Toggle the flashing behavior by clicking the slider after .
If changes were made, click the save icon () in the header.
Front panel brightness
There are multiple ways to change the brightness:
- Using the slider: drag the white ball over the slider until the desired amount is reached.
- Entering a value: enter any desired value between 10 and 100 in the input field.
- Using the + and - buttons: click on the to increase the value with one point and on the to decrease the value with one point.
If changes were made, click the save icon () in the header.
Invalid video behavior
Invalid video signals can create glitching or low quality images. These signals can be replaced with a solid black signal, thus preventing technical difficulties to be visible on screens during events.
Toggle whether the invalid signal must be shown or not by clicking the slider after .
If changes were made, click the save icon () in the header.