11.4 Activating and configuring the shutter

How to configure
  1. Power on the projector.

  2. Enable the XLR connector and set the output voltage to 24V. To do so, use one of the following:

    • Use the Front XLR connector menu in the projector OSD menu. For more info, see the Pulse OSD user guide.
    • Use the Front XLR connector panel in the Pulse Prospector software. For more info, see the Pulse Prospector user guide

  3. Use the shutter motor buttons to set the “mode” to one of the following:

    • mode 3 (clockwise) , or
    • mode 4 (counterclockwise).

    The shutter will perform a homing action. It will go to the “open” and “close” status of the chosen mode.

  4. Perform a visual check the homing action of the shutter.

    Make sure of the following:

    • Make sure that the lens is fully covered when the shutter is in “close” status.
    • Make sure the projected image is not covered by the shutter in “open” status.
    Warning: Make sure the shutter does not cover the lens when you are projecting images. This may damage both the shutter and the mounted lens (due to reflected light).
  5. Release the wing nuts to reposition the flap according to the shutter status.