4.5 Setting the projector addresses

Projector address
Address installed in the projector to be individually controlled via the RCU or via the serial communication.
Broadcast address
Projector will always execute the command coming from a RCU programmed with that broadcast address.
About individual projector address

As more than one projector can be installed in a room, each projector should be separately addressable with an RCU or with a computer using serial communication. Therefore each projector has its own address. The factory default individual projector address is ‘0’.

When the address is set, the projector can be controlled with the RCU. Only addresses between 0 and 31 are supported for the RCU.

Next to an individual projector address, each projector has also a broadcast address for group control.

About broadcast address

Broadcast address is a common address that can be set on the projector. That can be “0” or “1”. The default broadcast address is '0'.

Any command coming from an RCU programmed with that common address will be executed.

How to set

  1. In the main menu, select System Settings > Communication > IR Control.

    For detailed instructions see user guide of the projector.