4.3 Displaying and Programming addresses into the RCU

Projector address
Address installed in the projector to be individually controlled.
Broadcast address
Projector will always execute the command coming from a RCU programmed with that broadcast address.
Displaying the Projector Address on the Screen.

  1. If the projector is on, press the menu key and navigate to the Status page. The projector address and the broadcast address can be seen under the Communication heading.

    The projector's address is displayed on the LCD status screen and / or the OSD.

How to Program an Address into the RCU?
  1. Press the Address button until the Button pressed indicator lights up continuously (proximately 5 seconds).

  2. Enter the address with the digit buttons within the time the indicator lights up (also proximately 5 seconds).

    Note: That address can be any value between 0 and 31.
    Tip: A few examples:

    To enter address 3, press "3" digit button on the RCU to set the RCU's address to 3 and wait until the button pressed indicator is out. Alternatively, you can also press “0” and “3”. This way, the button pressed indicator goes out immediately.

    To enter address 31, then press “3” and “1” on the digit button on the RCU and the button pressed indicator goes out immediately.

Note: Placing new batteries in the remote control or plugging the remote to a projector via a cable will automatically reset the address back to its default value '0'.