2.6 VESA-mount installation

Caution: Use suitable mounting apparatus to avoid risk of injury.
Warning: Never move a display attached to an arm by pulling or pushing the display itself. Instead, make sure that the arm is equipped with a VESA compliant handle and use this to move the display.

Please refer to the instruction manual of the arm for more information and instructions.

Warning: Use a mount that is compliant with the VESA 100 mm standard.

Use a mount that can support the weight of the display. Refer to the technical specifications of this display for the applicable weight.

Overview

The panel, standard attached to the tilt & swivel foot, is compatible with the VESA 100 mm standard. So it can be used with an arm stand according to the VESA 100 mm standard.

Therefore, the tilt & swivel foot must be removed from the panel.

  1. Put the display in the lowest position and lock the height mechanism.

    Image 2–11
  2. Put the display face down on a clean and soft surface. Be careful not to damage the panel screen.

  3. Remove the plastic cover with a flathead screw driver.

    Image 2–12

  4. Slide the plastic cover over the neck of the foot.

    Image 2–13

  5. Remove the four screws fixing the foot while supporting the foot.

    Image 2–14
  6. Attach the arm stand firmly to the panel using 4 screws M4 x 8 mm.