10.2 Power up the projector

Caution: Sources should always be connected before the projector is powered up
Caution: Ensure that the main power cord complies with the national regulations where the equipment is used.

Do not use unauthorized replacements.

Do not use power cords which are damaged.

Power up the projector using the keypad or remote
  1. Plug the mains cord into the projector.

  2. Plug the mains cord into a grounded AC outlet.

    The projector starts up to READY mode as soon as the projector is connected with power net. The Power on/off button will blink until Ready mode is achieved. Once in Ready mode, the Power on/off button will be lit WHITE. The start up screen is displayed on the touch panel. Once the startup is completed, the status screen will be displayed.

    Image 10–1

  3. Press the power button on the keypad or the power button on the remote.

    The projector will continue to ON mode. The Power on/off button will blink until the projector is ready for projection. Once the projector is fully started up, the Power on/off button will be lit BLUE.

    Image 10–2
  4. When the power button backlight is solid blue, the projector is ready for use.