Controlling the projector in a multi-projector setup

As the Pulse RCU is programmed to work with any Pulse-powered projector, it should be understood that in a multi-projector setup, the Pulse RCU may control multiple (if not all) projectors at the same time. In order to control the projector there are two addresses that can be used:

• the individual projector address
• the group broadcast address

About the individual projector address

In a multi-projector setup, each projector should be addressed separately with a Pulse RCU. For this reason the individual projector address exists.

When the projector address is set, the projector can be controlled with an RCU programmed with the same address.

You can support up to 31 different addresses using this method. The default address is ‘1’.

About the group broadcast address

In a multi-projector setup, there are certain commands that have to be addressed to every projector in the setup (e.g. change power state, shutter open/close, etc). For this reason the group “broadcast address” exists.

The broadcast address can be either ‘0’ or ‘1’. The default address is '0'.

How to set

1. Do one of the following:

   1. In the Pulse OSD, select Settings > Communication > Remote Control.
   2. In Pulse Prospector, select Setup > Communication > Remote Control.
2. Set the desired Broadcast address.
3. Set the desired Projector address.
4. Click Apply and confirm.