11.2 Programming the projector address into the Pulse RCU

Projector address
Address installed in the projector to be individually controlled.
About the individual projector address

In a multi-projector setup, each projector should be addressed separately with a Pulse RCU. For this reason the individual projector address exists.

When the projector address is set, the projector can be controlled with an RCU programmed with the same address.

You can support up to 31 different addresses using this method. The default address is ‘1’.

How to program the projector address?
  1. Read the projector address from the projector you want to address with this Pulse RCU.
  2. Press the Address button until the Button pressed indicator lights up continuously (approximately 5 seconds).

  3. Enter the address with the digit buttons within the time the indicator lights up (also approximately 5 seconds).

    Tip: A few examples:

    To enter address 3, press "3" digit button on the RCU to set the RCU's address to 3 and wait until the button pressed indicator is out. Alternatively, you can also press “0” and “3”. This way, the button pressed indicator goes out immediately.

    To enter address 31, then press “3” and “1” on the digit button on the RCU and the button pressed indicator goes out immediately.

Note: Placing new batteries in the remote control or plugging the remote to a projector via a cable will automatically reset the address back to its default value '0'.