10.1 Power modes

General

The table below details the F70 power modes.

ModeDescription
ON (normal)Projector is booted up and the light source is on
READYProjector is booted up but the light source is off
ECO (Standby)Light source is switched off and projector electronics are powered down
Note: Energy consumption is significantly lowers in ECO (Standby) mode: only <0.5W if network is not plugged in and 2W with network (Wake-on-LAN).
Note: In ECO (Standby) mode, remote power up (Wake-on-LAN) and local power up (button) are supported.
Note: Wake-On-LAN (WOL)

The link speed of the projector network interface in ECO mode is reduced to 10Mbit/s. This is standard practice in the industry to not waste power. Hence, the network connected with the projector must support such a low link speed to enable the remote wake up of the projector. This implies that all peripherals (switchers, routers...) in the network path must support WOL and configured correctly to support WOL.