A.13 Specifications HDBase T input

Note:  The HDBaseT standard allows the link to also be used as a regular network port. In addition to carrying video data, it can also be connected to regular ethernet network without carry out any video data.

Due to limitations in the projector and network standards, only the LAN and the HDBaseT should be used for network traffic, but not both simultaneously. If both are connected simultaneously it might lead to undefined behavior where traffic is not being sent on the link indicated by the IPaddress.

This is only valid when the projector has a firmware version 2.1 or higher installed.

Specifications
ParameterValue
Reference specificationHDBaseT 1.0 Specification, June 2010
ConnectorStandard RJ-45, 8P8C
Signal characteristicsHDBaseT
Max. cable length (1080p/48b/60Hz)

100 m (Cat5e/6), Pixel Clock <=225HHz, Video Datarate <=5.3Gbps

70 m (Cat5e/6), Pixel Clock >225HHz, Video Datarate >5.3Gbps

100 m (Cat6a/7), Pixel Clock >225HHz, Video Datarate >5.3Gbps

Max TMDS Clock Frequency 270 MHz
Max video resolution supported4096x2160 @30Hz
HDCP Pass-ThroughYes, from Source to Projector
IR ExtensionNot Supported
RS-232 Extension Not Supported
10/100Mbps Ethernet Pass-Through Not Supported
Fallback to 100BaseTx, IEEE 802.3uNot Supported
USB Over Centre TapNot Supported
Power Over EthernetNot Supported
AudioNot Supported
LEDs - HD Base Status

Operation: Green, Left

Link/Mode: Yellow, Right